Published at Tuesday, December 31st 2019, 10:18:43 AM. Speaker Stands. By Cort Friedrich.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.
If you already have a pair of simple foam speaker platforms, you can improve their performance simply by gluing a heavy floor tile to the top. Ordinary contact adhesive works fine for this. Then you can either glue some kitchen mat to the upper surface, to provide some grip, or use Blu–Tack, as discussed earlier, between the tile and the loudspeaker.
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.
To sum up, the platforms with a heavy plate of some type on top are the most effective, though you can add mass very easily to any type of support by using floor tiles. Similarly, the more massive and better damped a speaker stand, the less vibrational energy is likely to make it through to the floor and less the stand itself will vibrate. Compared with the cost of speakers, adding suitable stands or platforms is relatively inexpensive, yet it can make a very worthwhile improvement to the overall sound quality!