Published at Thursday, January 02nd 2020, 13:26:13 PM. Speaker Stands. By Conradina Scholz.
Where vibrations are allowed to leak into any studio furniture or wooden floors, the audible result is often a blurring of the bass and lower mid range, as well as a deterioration in the stereo image. By using an appropriate stand or platform, the bass end should tighten up to a very noticeable degree, leaving the mids sounding clearer and the imaging better defined.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.
Subwoofers can be placed directly onto solid floors, but an isolation platform of some type will help clean up the sound if that floor is made of wood or chipboard. It isn’t a good idea to position subs very far from the floor — up to about 150mm shouldn’t present a problem, but more than that and the reflections can start to cause issues.
Even if you already have a loudspeaker stand, you can still use one of these foam–based speaker platforms on top of it to reduce the amount of vibration getting into the stand and subsequently into the floor. Many of the commercially available platforms come with additional foam wedges that may be used to adjust the vertical angle of the speaker if necessary.