By Wilde Becker. Speaker Stands. At Sunday, July 28th 2019, 19:39:28 PM.
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.
And stands do more than combatting early reflections. They also provide what’s called decoupling between your speakers and the floor (which is also known as mechanical isolation). We will let Otto describe their construction: “Take your typical Dynaudio Stand; you have feet with either spikes for solid floors or rubber for wooden ones at the bottom. Then you have a base plate that manages vibrations. Also, large base plates with feet far apart are more stable, making it harder for the speakers to fall over.