Published at Thursday, January 02nd 2020, 13:25:49 PM. Speaker Stands. By Emestina Krause.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.
You may have noticed that some speaker stands are fitted with spikes on the base, which help to make a rigid and stable contact with the floor. As long as the stands are both robust and stable, this strategy works well on solid floors, but you may find that it causes problems on wooden floors, due to vibrations from the speaker cabinet being transferred to the floor via the rigid stand and spikes. The floor will then act as the king of soundboards!
One of the roles of an effective speaker support is to prevent such vibrations from being transferred into other structures, such as wooden floors, desktops, shelves or mixer meterbridges. It should also hold the speaker as firmly as possible, to reduce movement due to the action/reaction effect.
The theory is that the mass and spring characteristics are chosen so that the resonant frequency of the combination is well below that of any frequency they’re likely to be asked to isolate. For example, if the lowest note a speaker can reproduce is 30Hz, then the resonant frequency of the supporting platform needs to be well below that — perhaps just a few Hertz or less.